SME - SERIES V-12

Viết đánh giá
219.820.000₫
Tình trạng: Còn hàng

SME - SERIES V-12

Bộ tay cần 12 inch được đúc áp lực từ magnesium, bao gồm cả headshell (máng) hoàn chỉnh nhằm hạn chế cộng hưởng từ thanh cần và giảm tới 27% độ sai biệt ở góc tiếp tuyến so với tay cần loại 9 inch. Nó cũng giúp tối thiểu lỗi bám rãnh (tracking) và giảm méo hài.

Series V-12 Dimensions  
A – Distance from pivot to stylus 308.80mm
B – Distance from pivot to turntable centre 295.60mm
C – Cartridge fixing centres 12.70mm
D – Offset angle 17.62°
E – Linear offset 93.47mm
F – Overhang 13.20mm
G – Height above mounting surface max. 87.90mm
min. 56.40mm
H – Height of record surface above mounting surface max. 55.90mm
min. 24.40mm
J – Depth below mounting surface 56.75mm
K – Radial clearance for balance weight 73.0mm

ADDITIONAL INFORMATION

  • The 12in pressure die-cast tone-arm utilises the advantages of magnesium and exploits the reduction in maximum tracking error/distortion afforded by the greater arm length when compared with 9in models.
  • Stainless steel cross shaft, ground and thread ground. Carried in massive yoke on Ø10mm precision ball races. Axes at record mean level to minimise warp-wow.
  • Dynamic balance. Graduated vertical tracking force control applies up to 3.0g x 0.125g VTF through resonance controlled spring.
  • Stainless steel vertical shaft, ground and thread ground, with integral Ø16mm flange to couple shaft and yoke.
  • Ø23mm steel pillar, heat treated, ground and honed, carries two Ø17mm precision ball races, widely spaced to resist tilt.
  • Underslung weight housing corrects centre of gravity and provides non-reflective tone-arm termination.
  • Internal constrained layer damps minute residual vibration leaving the tone-arm acoustically inert.
  • Fine machined cartridge platform, enamel free to avoid interface resonance.
  • Swivelling, damped output socket minimises vibration transmission in sub-chassis use.
  • Tungsten-alloy balance carried on two-point suspension. Extra-low inertia design assists warp riding.
  • Subsonic lateral-mode damper can be instantly adjusted or cancelled.
  • Anti-skate control operates through tension spring and filament. Dial corresponds with VTF and has a positive OFF position.
  • Lowering/raising control gives smooth positive action. Height of lift can be adjusted.
  • Dual-lock base provides movement control with high rigidity.
  • Fine adjustment of horizontal tracking angle (HTA).
  • Reference lines on tone-arm facilitate VTA setting.
  • Fine adjustment of horizontal tracking angle (HTA).
Series V-12 Specifications  
Effective mass 12.0g
Cartridge balance range 5.0 – 32.0g
+ One accessory weight – up to 26.5g
+ Two accessory weight – up to 32.0g
Maximum tracking error 0.009°/mm
Null points Inner 66.04mm
Outer 120.90mm
Internal wiring Ultra-flexible Silver litz
Audio lead Length 1.2m
Weight net 815.0g

Series V Tonearm Manual (PDF)

V-12 Additional Information

 

Sản phẩm bạn đã xem

popup

Số lượng:

Tổng tiền:

Xin chào
close nav
0908 287 626